Compliance with following international standards
ASTM D2440, IP 280Introduction
This test method determines the resistance of mineral transformer oils to oxidation under prescribed accelerated aging conditions. Oxidation stability is measured by the propensity of oils to form sludge and acid products during oxidation.Significance & Use
A test specimen of mineral transformer oil is oxidized at bath temperature of 110 °C/95 °C, in the presence of a copper catalyst coil, by bubbling oxygen through duplicate test specimens for 72 and 164 h, respectively. The oil is evaluated at the end of each aging period by measuring the amount of sludge and acid formed. The test specimen is diluted with n-heptane and the solution filtered to remove the sludge. The sludge is then dried and weighed.
4 nos. test vessel / tube made of borosilicate glass provided with a B -24 cone and having the followingOxygen inlet tube Dimensions:
One Thermostatic block of following features:
- External dia : 5.0 /- 0.4mm
- Wall thickness : 0.8 /- 0.1 mm
- The test tube is fitted with a Drechsel head to which is attached the inlet tube which will extended within /- 2 - 3 mm of the bottom and its end ground at an angle of 60 deg to the horizontal axis as per fig 1 of IS :335 : 1993
Metallic Copper Catalyst of following dimension:
- It is made of wrought aluminum block provided with four holes to accommodate four test vessels / tubes, provided with a digital PID controller, capable of maintaining the oil temperature at 100.0 /- 0.5 deg C. 4 nos.
Rotameters of following features:
- Copper catalysts consist of a wire of non - annealed commercial electrolytic copper of diameter between 1.00 and 1.02 mm. and wire shall have a length of 305 /- 1.0 mm rolled into a spiral of approx 20 mm external diameter and 50 mm in length.
- These are rotameter type flowmeters with the capacity to measure the flow rate of oxygen in the range 1 /- 0.1 litre / hour.
- Rated Voltage: AC220V±10% 50Hz
- Power: 2400W
- Bath Temperature: 95ºC
- Temperature Control Precision: ±0.2ºC
- Testing Bomb: 6